CCNA 200-301 Exam Free Dumps | 100% Free, Complete & Latest Dumps with the Most Recent Updates

Pass CCNA 200-301 in Just 3 Days – Stress-Free!

Get your CCNA 200-301 certification with 100% pass guarantee. Pay only after passing!
Click here to secure your guaranteed certification now!
Have questions? Contact us directly on WhatsApp for quick support!

A network administrator is evaluating network security in the aftermath of an attempted ARP spoofing attack. If Port-channel1 is the uplink interface of the access-layer switch toward the distribution-layer switch, which two configurations must the administrator configure on the access-layer switch to provide adequate protection? (Choose two.)

Which IPsec encryption mode is appropriate when the destination of a packet differs from the security termination point?

Which interface is used to send traffic to the destination network?

• A. G0/9
• B. G0/12
• C. G0/19
• D. G0/1

DRAG DROP
–

Drag and drop the characteristic from the left onto the cable type on the right.

Refer to the exhibit. Which switch becomes the root bridge?

DRAG DROP
–

Drag and drop the characteristic from the left onto the IPv6 address type on the right.

SIMULATION
–

Guidelines
–

This is a lab item in which tasks will be performed on virtual devices.

• Refer to the Tasks tab to view the tasks for this lab item.
• Refer to the Topology tab to access the device console(s) and perform the tasks
• Console access is available for all required devices by clicking the device icon or using the tab(s) above the console window
• All necessary preconfigurations have been applied
• Do not change the enable password or hostname for any device
• Save your configurations to NVRAM before moving to the next item
• Click Next at the bottom of the screen to submit this lab and move to the next question
• When Next is clicked the lab closes and cannot be reopened

Topology
–

Tasks
–

IP connectivity between the three routers is configured. OSPF adjacencies must be established.

1. Configure R1 and R2 Router IDs using the interface IP addresses from the link that is shared between them.
2. Configure the R2 links with a max value facing R1 and R3. R2 must become the DR. R1 and R3 links facing R2 must remain with the default OSPF configuration for DR election. Verify the configuration after clearing the OSPF process.
3. Using a host wildcard mask, configure all three routers to advertise their respective Loopback1 networks.
4. Configure the link between R1 and R3 to disable their ability to add other OSPF routers.

Answer:

Refer to the exhibit. An engineer is configuring a new router on the network and applied this configuration. Which additional configuration allows the PC to obtain its IP address from a DHCP server?