Pass CCNA 200-301 in Just 3 Days – Stress-Free!
Get your CCNA 200-301 certification with 100% pass guarantee. Pay only after passing!
Click here to secure your guaranteed certification now!
Have questions? Contact us directly on WhatsApp for quick support!
Refer to the exhibit. The iPv6 address for the LAN segment on router R2 must be configured using the EUI-64 format. Which address must be used?
- A. ipv6 address 2001:DB8:D8D2:1009:10A0:ABFF:FECC:1 eui-64
- B. ipv6 address 2001:DB8:D8D2:1009:1230:ABFF:FECC:1 eui-64
- C. ipv6 address 2001:DB8:D8D2:1009:4347:31FF:FF47:0 eui-64
- D. ipv6 address 2001:DB8:D8D2:1009:12A0:AB34:FFCC:1 eui-64
Which two host addresses are reserved for private use within an enterprise network? (Choose two.)
- A. 10.172.76.200
- B. 12.17.1.20
- C. 172.15.2.250
- D. 172.31.255.100
- E. 192.169.32.10
Refer to the exhibit. Traffic that is flowing over interface TenGigabitEthemet0/0/0 experiences slow transfer speeds. What is the cause of this issue?
- A. speed conflict
- B. queuing drops
- C. duplex incompatibility
- D. heavy traffic congestion
Two switches have been implemented and all interfaces are at the default configuration level. A trunk link must be implemented between two switches with these requirements:
• using an industry-standard trunking protocol
• permitting VLANs 1-10 and denying other VLANs
How must the interconnecting ports be configured?
- A. switchport mode dynamic
channel-protocol lacp
switchport trunk allowed vlans 1-10 - B. switchport mode trunk
switchport trunk allowed vlans 1-10
switchport trunk native vlan 11 - C. switchport mode trunk
switchport trunk encapsulation dot1q
switchport trunk allowed vlans 1-10 - D. switchport mode dynamic desirable
channel-group 1 mode desirable
switchport trunk encapsulation isl
switchport trunk allowed vlan except 11-4094
What is the benefit of using private IPv4 addressing?
- A. to enable secure connectivity over the Internet
- B. to shield internal network devices from external access
- C. to provide reliable connectivity between like devices
- D. to be routable over an external network
Which two protocols are supported on service-port interfaces? (Choose two.)
- A. Telnet
- B. SCP
- C. TACACS+
- D. SSH
- E. RADIUS
Refer to the exhibit. A Cisco engineer is asked to update the configuration on switch 1 so that the EtherChannel stays up when one of the links fails. Which configuration meets this requirement?
- A. Switch1(config) # interface Fa0/0
Switch1(config-if) # lacp port-priority 100
Switch1(config) # interface Fa0/1
Switch1(config-if) # lacp port-priority 200 - B. Switch1(config) # interface port-channel 1
Switch1(config-if) # port-channel min-links 1 - C. Switch1(config) # interface Fa0/0
Switch1(config-if) # lacp port-priority 200
Switch1(config) # interface Fa0/1
Switch1(config-if) # lacp port-priority 100 - D. Switch1(config) # interface port-channel 1
Switch1(config-if) # lacp max-bundle 1
What does traffic shaping do?
- A. It queues excess traffic
- B. It sets QoS attributes within a packet
- C. It organizes traffic into classes
- D. It modifies the QoS attributes of a packet
Which QoS feature drops traffic that exceeds the committed access rate?
- A. policing
- B. FIFO
- C. shaping
- D. weighted fair queuing
Refer to the exhibit. The IPv6 address for the LAN segment on router R2 must be configured using the EUI-64 format. When configured which ipv6 address is produced by the router?
- A. 2001:db8:9aa6:6aa9:C801:A6FF:FEA4:1
- B. 2001:db8:9aa6:6aa9:C081:A6FF:FF4A:1
- C. 2001:db8:9aa6:6aa9:C001:6AFE:FF00:1
- D. 2001:db8:9aa6:6aa9:4642:823F:FE47:1