Pass CCNA 200-301 in Just 3 Days – Stress-Free!
Get your CCNA 200-301 certification with 100% pass guarantee. Pay only after passing!
Click here to secure your guaranteed certification now!
Have questions? Contact us directly on WhatsApp for quick support!
Refer to the exhibit. Which next-hop IP address has the least desirable metric when sourced from R1?
- A. 10.10.10.4
- B. 10.10.10.5
- C. 10.10.10.3
- D. 10.10.10.2
Refer to the exhibit. Router R14 is in the process of being configured. Which configuration must be used to establish a host route to a PC 10?
- A. ip route 10.80.65.10 255.255.255.254 10.80.65.1
- B. ip route 10.80.65.10 255.255.255.255 10.73.65.66
- C. ip route 10.73.65.66 0.0.0.255 10.80.65.10
- D. ip route 10.73.65.66 255.0.0.0 10.80.65.10
Refer to the exhibit. What does route 10.0.1.3/32 represent in the routing table?
- A. all hosts in the 10.0.1.0 subnet
- B. a single destination address
- C. the source 10.0.1.100
- D. the 10.0.0.0 network
Refer to the exhibit. A network engineer started to configure two directly-connected routers as shown. Which command sequence must the engineer configure on R2 so that the two routers become OSPF neighbors?
- A. interface GigabitEthernet0/1
ip ospf 1 area 1 - B. router ospf 1
network 192.168.12.1 0.0.0.0 area 1 - C. interface GigabitEthernet0/1
ip ospf 1 area 0 - D. router ospf 1
network 192.168.12.0 0.0.0.127 area 0
A network engineer is upgrading a small data center to host several new applications, including server backups that are expected to account for up to 90% of the bandwidth during peak times. The data center connects to the MPLS network provider via a primary circuit and a secondary circuit. How does the engineer inexpensively update the data center to avoid saturation of the primary circuit by traffic associated with the backups?
- A. Assign traffic from the backup servers to a dedicated switch.
- B. Place the backup servers in a dedicated VLAN.
- C. Advertise a more specific route for the backup traffic via the secondary circuit.
- D. Configure a dedicated circuit for the backup traffic.
Which interface is used for out-of-band management on a WLC?
- A. management
- B. virtual
- C. dynamic
- D. service port
A wireless access point is needed and must meet these requirements:
• “zero-touch” deployed and managed by a WLC
• process only real-time MAC functionality
• used in a split-MAC architecture
Which access point type must be used?
- A. mesh
- B. autonomous
- C. lightweight
- D. cloud-based
What is a reason to implement LAG on a Cisco WLC?
- A. Allow for stateful failover between WLCs.
- B. Increase security by encrypting management frames.
- C. Increase the available throughput on the link.
- D. Enable the connected switch ports to use different Layer 2 configurations.
Which step immediately follows receipt of the EAP success message when session resumption is disabled for an EAP-TLS connection?
- A. PMKID caching
- B. four-way handshake
- C. 802.1X authentication
- D. EAPOL-key frame
Which port type does a lightweight AP use to connect to the wired network when it is configured in local mode?
- A. EtherChannel
- B. access
- C. LAG
- D. trunk