Pass CCNA 200-301 in Just 3 Days – Stress-Free!
Get your CCNA 200-301 certification with 100% pass guarantee. Pay only after passing!
Click here to secure your guaranteed certification now!
Have questions? Contact us directly on WhatsApp for quick support!
DRAG DROP –
Drag and drop the IPv6 address type characteristics from the left to the right.
Select and Place:
DRAG DROP –
Refer to the exhibit. The IP address configurations must be completed on the DC-1 and HQ-1 routers based on these requirements:
✑ DC-1 Gi1/0 must be the last usable address on a /30
✑ DC-1 Gi1/1 must be the first usable address on a /29
✑ DC-1 Gi1/2 must be the last usable address on a /28
✑ HQ-1 Gi1/3 must be the last usable address on a /29
Drag and drop the commands from the left onto the destination interfaces on the right. Not all commands are used.
Select and Place:
How is RFC 1918 addressing used in a network?
- A. They are used to access the Internet from the internal network without conversion.
- B. They are used in place of public addresses for Increased security.
- C. They are used with NAT to preserve public IPv4 addresses.
- D. They are used by Internet Service Providers to route over the Internet.
DRAG DROP –
Drag and drop the IPv6 address types from the left onto their descriptions on the right.
Select and Place:
Refer to the exhibit. What is a reason for poor performance on the network interface?
- A. The interface is receiving excessive broadcast traffic.
- B. The bandwidth setting of the interface is misconfigured.
- C. The cable connection between the two devices is faulty.
- D. The interface is operating at a different speed than the connected device.
DRAG DROP –
Drag and drop the IPv6 address descriptions from the left onto the IPv6 address types on the right. Not all options are used.
Select and Place:
DRAG DROP –
Drag and drop the IPv6 addresses from the left onto the corresponding address types on the right.
Select and Place:
Which WAN topology has the highest degree of reliability?
- A. point-to-point
- B. router-on-a-stick
- C. full mesh
- D. hub-and-spoke
DRAG DROP –
Drag and drop the IPv6 address type characteristics from the left to the right.
Select and Place:
What causes a port to be placed in the err-disabled state?
- A. nothing plugged into the port
- B. link flapping
- C. latency
- D. shutdown command issued on the port