Pass CCNA 200-301 in Just 3 Days – Stress-Free!
Get your CCNA 200-301 certification with 100% pass guarantee. Pay only after passing!
Click here to secure your guaranteed certification now!
Have questions? Contact us directly on WhatsApp for quick support!
Refer to the exhibit. Which switch in this configuration will be elected as the root bridge?
SW1: 0C:E0:38:41:86:07 –
SW2: 0C:0E:15:22:05:97 –
SW3: 0C:0E:15:1A:3C:9D –
SW4: 0C:E0:18:A1:B3:19 –
- A. SW1
- B. SW2
- C. SW3
- D. SW4
DRAG DROP –
Refer to the exhibit. An engineer is required to verify that the network parameters are valid for the users’ wireless LAN connectivity on a /24 subnet. Drag and drop the values from the left onto the network parameters on the right. Not all values are used.
Select and Place:
An engineer needs to configure LLDP to send the port description type length value (TLV). Which command sequence must be implemented?
- A. switch(config-if)#lldp port-description
- B. switch#lldp port-description
- C. switch(config-line)#lldp port-description
- D. switch(config)#lldp port-description
Refer to the exhibit. Which switch becomes the root bridge?
- A. S1
- B. S2
- C. S3
- D. S4
Which configuration ensures that the switch is always the root for VLAN 750?
- A. Switch(config)#spanning-tree vlan 750 priority 38418607
- B. Switch(config)#spanning-tree vlan 750 priority 0
- C. Switch(config)#spanning-tree vlan 750 root primary
- D. Switch(config)#spanning-tree vlan 750 priority 614440
Refer to the exhibit. After the switch configuration, the ping test fails between PC A and PC B. Based on the output for switch 1, which error must be corrected?
- A. The PCs are in the incorrect VLAN.
- B. All VLANs are not enabled on the trunk.
- C. Access mode is configured on the switch ports.
- D. There is a native VLAN mismatch.
DRAG DROP –
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Select and Place:
Reference:
https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/config-guide/b_cg85/ports_and_interfaces.html
Which unified access point mode continues to serve wireless clients after losing connectivity to the Cisco Wireless LAN Controller?
- A. local
- B. mesh
- C. flexconnect
- D. sniffer
Refer to the exhibit. Which command provides this output?
- A. show ip route
- B. show cdp neighbor
- C. show ip interface
- D. show interface
Which mode must be used to configure EtherChannel between two switches without using a negotiation protocol?
- A. active
- B. on
- C. auto
- D. desirable