Pass CCNA 200-301 in Just 3 Days – Stress-Free!
Get your CCNA 200-301 certification with 100% pass guarantee. Pay only after passing!
Click here to secure your guaranteed certification now!
Have questions? Contact us directly on WhatsApp for quick support!
Which WLC interface provides out-of-band management in the Cisco Unified Wireless Network Architecture?
- A. AP-Manager
- B. service port
- C. dynamic
- D. virtual
Refer to the exhibit. The network engineer is configuring a new WLAN and is told to use a setup password for authentication instead of the RADIUS servers.
Which additional set of tasks must the engineer perform to complete the configuration?
- A. Disable PMF Enable PSK Enable 802.1x
- B. Select WPA Policy Enable CCKM Enable PSK
- C. Select WPA Policy Select WPA2 Policy Enable FT PSK
- D. Select WPA2 Policy Disable PMF Enable PSK
Which mode must be set for Aps to communicate to a Wireless LAN Controller using the Control and Provisioning of Wireless Access Points (CAPWAP) protocol?
- A. route
- B. bridge
- C. lightweight
- D. autonomous
Which switch technology establishes a network connection immediately when it is plugged in?
- A. PortFast
- B. BPDU guard
- C. UplinkFast
- D. BackboneFast
Which command on a port enters the forwarding state immediately when a PC is connected to it?
- A. switch(config)#spanning-tree portfast default
- B. switch(config)#spanning-tree portfast bpduguard default
- C. switch(config-if)#spanning-tree portfast trunk
- D. switch(config-if)#no spanning-tree portfast
If a switch port receives a new frame while it is actively transmitting a previous frame, how does it process the frames?
- A. The new frame is delivered first, the previous frame is dropped, and a retransmission request is sent
- B. The previous frame is delivered, the new frame is dropped, and a retransmission request is sent
- C. The new frame is placed in a queue for transmission after the previous frame
- D. The two frames are processed and delivered at the same time
Refer to the exhibit. The entire MAC address table for SW1 is shown here:
What does SW1 do when Br-4 sends a frame for Br-2
- A. It performs a lookup in the MAC address table for Br-4 and discards toe frame due to a missing entry.
- B. It floods the frame out or all ports except on the port where Br-2 is connected.
- C. It Inserts the source MAC address and port into the forwarding table and forwards the frame to Br-2.
- D. It maps the Layer 2 MAC address for Fa0/3 to the Layer 3 IP address and towards the frame.
How does MAC learning function?
- A. adds unknown source MAC addresses to the CAM table
- B. protects against denial of service attacks
- C. populates the ARP table with the egress port
- D. sends an ARP request to locate unknown destinations
Refer to the exhibit. An engineer is configuring an EtherChannel using LACP between Switches 1 and 2.
Which configuration must be applied so that only Switch 1 sends LACP initiation packets?
A
B
C
D
Correct Answer: B
Refer to the exhibit. The entire Marketing-SW1 MAC address table is shown here:
What does the switch do when PC-4 sends a frame to PC-1?
A. It performs a lookup in the MAC address table and discards the frame due to a missing entry.
B. It maps the Layer 2 MAC address to the Layer 3 IP address and forwards the frame.
C. It inserts the source MAC address and port into the table and forwards the frame to PC-1. Most Voted
D. It floods the frame out of all ports except on the port where PC-1 is connected.