Pass CCNA 200-301 in Just 3 Days – Stress-Free!
Get your CCNA 200-301 certification with 100% pass guarantee. Pay only after passing!
Click here to secure your guaranteed certification now!
Have questions? Contact us directly on WhatsApp for quick support!
What is the primary different between AAA authentication and authorization?
A. Authentication verifies a username and password, and authorization handles the communication between the authentication agent and the user database.
B. Authentication identifies a user who is attempting to access a system, and authorization validates the users password
C. Authentication identifies and verifies a user who is attempting to access a system, and authorization controls the tasks the user can perform.
D. Authentication controls the system processes a user can access and authorization logs the activities the user initiates
When a floating static route is configured, which action ensures that the backup route is used when the primary route fails?
A. The floating static route must have a higher administrative distance than the primary route so it is used as a backup
B. The administrative distance must be higher on the primary route so that the backup route becomes secondary.
C. The floating static route must have a lower administrative distance than the primary route so it is used as a backup
D. The default-information originate command must be configured for the route to be installed into the routing table
Which two outcomes are predictable behaviors for HSRP? (Choose two)
A. The two routers share a virtual IP address that is used as the default gateway for devices on the LAN.
B. The two routers negotiate one router as the active router and the other as the standby router
C. Each router has a different IP address both routers act as the default gateway on the LAN, and traffic is load balanced between them.
D. The two routers synchronize configurations to provide consistent packet forwarding
E. The two routed share the same IP address, and default gateway traffic is load-balanced between them
Refer to the exhibit. Which password must an engineer use to enter the enable mode?
A. adminadmin123
B. default
C. testing1234
D. cisco123
How do TCP and UDP differ in the way that they establish a connection between two endpoints?
A. TCP uses synchronization packets, and UDP uses acknowledgment packets.
B. UDP uses SYN,SYN ACK and FIN bits in the frame header while TCP uses SYN,SYN ACK and ACK bits
C. UDP provides reliable message transfer and TCP is a connectionless protocol
D. TCP uses the three-way handshake and UDP does not guarantee message delivery
When a site-to-site VPN is used, which protocol is responsible for the transport of user data?
A. IKEv2
B. IKEv1
C. IPsec
D. MD5
What is the primary effect of the spanning-tree port fast command?
A. it enables BPDU messages
B. It minimizes spanning-tree convergence time
C. It immediately puts the port into the forwarding state when the switch is reloaded
D. It immediately enables the port in the listening state
How will Link Aggregation be implemented on a Cisco Wireless LAN Controller?
A. To pass client traffic two or more ports must be configured.
B. The EtherChannel must be configured in “mode active”
C. When enabled the WLC bandwidth drops to 500 Mbps
D. One functional physical port is needed to pass client traffic
Refer to the exhibit. Which route does R1 select for traffic that is destined to 192 168.16.2?
A. 192.168.16.0/21
B. 192.168.16.0/24
C. 192.168 26.0/26
D. 192.168.16.0/27
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)
A. Enable NTP authentication.
B. Verify the time zone.
C. Disable NTP broadcasts
D. Specify the IP address of the NTP server
E. Set the NTP server private key