Pass CCNA 200-301 in Just 3 Days – Stress-Free!
Get your CCNA 200-301 certification with 100% pass guarantee. Pay only after passing!
Click here to secure your guaranteed certification now!
Have questions? Contact us directly on WhatsApp for quick support!
Which command should you enter to verify the priority of a router in an HSRP group?
A. show hsrp
B. show sessions
C. show interfaces
D. show standby
Which command should you enter to configure a device as an NTP sever?
A. ntp sever
B. ntp peer
C. ntp authenticate
D. ntp master
Which two pieces of information can you determine from the output of the show ntp status command? (Choose two)
A. whether the NTP peer is statically configured
B. the IP address of the peer to which the clock is synchronized
C. the configured NTP servers
D. whether the clock is synchronized
E. the NTP version number of the peer
Which effete does the aaa new-model configuration command have?
A. It enables AAA services on the device
B. It configures the device to connect to a RADIUS server for AAA
C. It associates a RADIUS server to an group.
D. It configures a local user on the device.
Refer to the exhibit. Which command would you use to configure a static route on Router1 to network 192.168.202.0/24 with a nondefault administrative distance?
A. router1(config)#ip route 192.168.202.0 255.255.255.0 192.168.201.2 1
B. router1(config)#ip route 192.168.202.0 255.255.255.0 192.168.201.2 5
C. router1(config)#ip route 1 192.168.201.1 255.255.255.0 192.168.201.2
D. router1(config)#ip route 5 192.168.202.0 255.255.255.0 192.168.201.2
What is the destination MAC address of a broadcast frame?
A. 00:00:0c:07:ac:01
B. ff:ff:ff:ff:ff:ff
C. 43:2e:08:00:00:0c
D. 00:00:0c:43:2e:08
E. 00:00:0c:ff:ff:ff
Which command is used to enable LLDP globally on a Cisco IOS ISR?
A. lldp run
B. lldp enable
C. lldp transmit
D. cdp run
E. cdp enable
Which of the following dynamic routing protocols are Distance Vector routing protocols?
A. IS-IS
B. EIGRP
C. OSPF
D. BGP
E. RIP
You have configured a router with an OSPF router ID, but its IP address still reflects the physical interface. Which action can you take to correct the problem in the least disruptive way?
A. Reload the OSPF process.
B. Specify a loopback address
C. Reboot the router.
D. Save the router configuration
Drag and Drop Question
Drag and drop the benefits of a cisco wireless Lan controller from the left onto the correct examples on the right.
