Pass CCNA 200-301 in Just 3 Days – Stress-Free!
Get your CCNA 200-301 certification with 100% pass guarantee. Pay only after passing!
Click here to secure your guaranteed certification now!
Have questions? Contact us directly on WhatsApp for quick support!
In a CDP environment, what happens when the CDP interface on an adjacent device is configured without an IP address?
A. CDP becomes inoperable on that neighbor
B. CDP uses the IP address of another interface for that neighbor
C. CDP operates normally,but it cannot provide IP address information for that neighbor
D. CDP operates normally,but it cannot provide any information for that neighbor
Refer to the exhibit. When PC 1 sends a packet to PC2,the packet has. Which source and destination IP address when it arrives at interface Gi0/0 on router R2?
A. source 192.168.10.10 and destination 10.10.2.2
B. source 192.168.20.10 and destination 192.168.20.1
C. source 192.168.10.10 and destination 192.168.20.10
D. source 10.10.1.1 and destination 10.10.2.2
Which feature or protocol determines whether the QOS on the network is sufficient to support IP services?
A. LLDP
B. CDP
C. IP SLA
D. EEM
An email user has been lured into clicking a link in an email sent by their company’s security organization. The webpage that opens reports that it was safe but the link could have contained malicious code. Which type of security program is in place?
A. Physical access control
B. Social engineering attack
C. brute force attack
D. user awareness
What is the default behavior of a Layer 2 switch when a frame with an unknown destination MAC address is received?
A. The Layer 2 switch drops the received frame
B. The Layer 2 switch floods packets to all ports except the receiving port in the given VLAN.
C. The Layer 2 switch sends a copy of a packet to CPU for destination MAC address learning.
D. The Layer 2 switch forwards the packet and adds the destination MAC address to its MAC address table
Refer to the exhibit. An engineer configured NAT translations and has verified that the configuration is correct.
Which IP address is the source IP after the NAT has taken place?
A. 10.4.4.4
B. 10.4.4.5
C. 172.23.103.10
D. 172.23.104.4
Refer to the exhibit. The New York router is configured with static routes pointing to the Atlanta and Washington sites.
Which two tasks must be performed so that the Serial0/0/0 interfaces on the Atlanta and Washington routers can reach one another? (Choose two.)
A. Configure the ipv6 route 2012::/126 2023::1 command on the Washington router
B. Configure the ipv6 route 2023::/126 2012::1 command on the Atlanta router.
C. Configure the Ipv6 route 2012::/126 s0/0/0 command on the Atlanta router
D. Configure the ipv6 route 2023::/126 2012::2 command on the Atlanta router
E. Configure the ipv6 route 2012::/126 2023::2 command on the Washington router
A user configured OSPF and advertised the Gigabit Ethernet interface in OSPF By default, which type of OSPF network does this interface belong to?
A. point-to-multipoint
B. point-to-point
C. broadcast
D. nonbroadcast
An engineer is asked to protect unused ports that are configured in the default VLAN on a switch. Which two steps will fulfill the request? (Choose two)
A. Configure the ports in an EtherChannel.
B. Administratively shut down the ports
C. Configure the port type as access and place in VLAN 99
D. Configure the ports as trunk ports
E. Enable the Cisco Discovery Protocol
Which output displays a JSON data representation?
A
B
C
D
Answer: D