Pass CCNA 200-301 in Just 3 Days – Stress-Free!
Get your CCNA 200-301 certification with 100% pass guarantee. Pay only after passing!
Click here to secure your guaranteed certification now!
Have questions? Contact us directly on WhatsApp for quick support!
Which IPv6 address block sends packets to a group address rather than a single address?
A. 2000::/3
B. FC00::/7
C. FE80::/10
D. FF00::/8
Which feature or protocol is required for an IP SLA to measure UDP jitter?
A. LLDP
B. EEM
C. CDP
D. NTP
Which two pieces of information can you learn by viewing the routing table? (Choose two)
A. whether an ACL was applied inbound or outbound to an interface
B. the EIGRP or BGP autonomous system
C. whether the administrative distance was manually or dynamically configured
D. Which neighbor adjacencies are established
E. the length of time that a route has been known
Refer to the exhibit. Which two events occur on the interface,if packets from an unknown Source address arrive after the interface learns the maximum number of secure MAC address? (Choose two)
A. The security violation counter dose not increment
B. The port LED turns off
C. The interface is error-disabled
D. A syslog message is generated
E. The interface drops traffic from unknown MAC address
Refer to the exhibit. Which feature is enabled by this configuration?
A. static NAT translation
B. a DHCP pool
C. a dynamic NAT address pool
D. PAT
For what two purposes does the Ethernet protocol use physical addresses?
A. to uniquely identify devices at Layer 2
B. to allow communication with devices on a different network
C. to differentiate a Layer 2 frame from a Layer 3 packet
D. to establish a priority system to determine which device gets to transmit first
E. to allow communication between different devices on the same network
F. to allow detection of a remote device when its physical address is unknown
Refer to Exhibit. An engineer is configuring the NEW York router to reach the Lo1 interface of the Atlanta router using interface Se0/0/0 as the primary path.
Which two commands must be configured on the New York router so that it can reach the Lo1 interface of the Atlanta router via Washington when the link between New York and Atlanta goes down? (Choose two)
A. ipv6 router 2000::1/128 2012::1
B. ipv6 router 2000::1/128 2012::1 5
C. ipv6 router 2000::1/128 2012::2
D. ipv6 router 2000::1/1282023::2 5
E. ipv6 router 2000::1/1282023::3 5
Refer to Exhibit. How does SW2 interact with other switches in this VTP domain?
A. It processes VTP updates from any VTP clients on the network on its access ports.
B. It receives updates from all VTP servers and forwards all locally configured VLANs out all trunk ports
C. It forwards only the VTP advertisements that it receives on its trunk ports.
D. It transmits and processes VTP updates from any VTP Clients on the network on its trunk ports
Drag and Drop Question
Drag and drop the networking parameters from the left on to the correct values on the right.
Drag and Drop Question
A network engineer is configuring an OSPFv2 neighbor adjacency. Drag and drop the parameters from the left onto their required categories on the right. No all parameters are used.
