Pass CCNA 200-301 in Just 3 Days – Stress-Free!
Get your CCNA 200-301 certification with 100% pass guarantee. Pay only after passing!
Click here to secure your guaranteed certification now!
Have questions? Contact us directly on WhatsApp for quick support!
Which device permits or denies network traffic based on a set of rules?
A. firewall
B. switch
C. access point
D. wireless controller
An office has 8 floors with approximately 30-40 users per floor.
What command must be configured on the router Switched Virtual Interface to use address space efficiently?
A. ip address 192.168.0.0 255.255.0.0
B. ip address 192.168.0.0 255.255.254.0
C. ip address 192.168.0.0 255.255.255.128
D. ip address 192.168.0.0 255.255.255.224
A wireless administrator has configured a WLAN; however, the clients need access to a less congested 5-GHz network for their voice quality. What action must be taken to meet the requirement?
A. enable AAA override
B. enable RX-SOP
C. enable DTIM
D. enable Band Select
Refer to the exhibit. A packet is being sent across router R1 to host 172.16.0.14. What is the destination route for the packet?
A. 209.165.200.254 via Serial0/0/1
B. 209.165.200.254 via Serial0/0/0
C. 209.165.200.246 via Serial0/1/0
D. 209.165.200.250 via Serial0/0/0
Which configuration ensures that the switch is always the root for VLAN 750?
A. Switch(config)#spanning-tree vlan 750 priority 38003685
B. Switch(config)#spanning-tree vlan 750 root primary
C. Switch(config)#spanning-tree vlan 750 priority 614440
D. Switch(config)#spanning-tree vlan 750 priority 0
Refer to the exhibit. An engineer booted a new switch and applied this configuration via the console port. Which additional configuration must be applied to allow administrators to authenticate directly to enable privilege mode via Telnet using a local username and password?
A. Option A
B. Option B
C. Option C
D. Option D
Refer to the exhibit. Which switch becomes the root bridge?
A. S1
B. S2
C. S3
D. S4
Refer to the exhibit. Which route type does the routing protocol Code D represent in the output?
A. internal BGP route
B. /24 route of a locally configured IP
C. statically assigned route
D. route learned through EIGRP
What protocol allows an engineer to back up 20 network router configurations globally while using the copy function?
A. SMTP
B. SNMP
C. TCP
D. FTP
An engineer must configure an OSPF neighbor relationship between router R1 and R3. The authentication configuration has been configured and the connecting interfaces are in the same 192.168.1.0/30 subnet. What are the next two steps to complete the configuration? (Choose two.)
A. configure the hello and dead timers to match on both sides
B. configure the same process ID for the router OSPF process
C. configure the same router ID on both routing processes
D. Configure the interfaces as OSPF active on both sides.
E. configure both interfaces with the same area ID