Pass CCNA 200-301 in Just 3 Days – Stress-Free!
Get your CCNA 200-301 certification with 100% pass guarantee. Pay only after passing!
Click here to secure your guaranteed certification now!
Have questions? Contact us directly on WhatsApp for quick support!
What does a switch use to build its MAC address table?
A. VTP
B. DTP
C. egress traffic
D. ingress traffic
Which device tracks the state of active connections in order to make a decision to forward a packet through?
A. wireless access point
B. firewall
C. wireless LAN controller
D. router
How do servers connect to the network in a virtual environment?
A. wireless to an access point that is physically connected to the network
B. a cable connected to a physical switch on the network
C. a virtual switch that links to an access point that is physically connected to the network
D. a software switch on a hypervisor that is physically connected to the network
What is recommended for the wireless infrastructure design of an organization?
A. group access points together to increase throughput on a given channel
B. configure the first three access points are configured to use Channels 1, 6, and 11
C. include a least two access points on nonoverlapping channels to support load balancing
D. assign physically adjacent access points to the same Wi-Fi channel
Which 802.11 frame type is indicated by a probe response after a client sends a probe request?
A. action
B. management
C. control
D. data
Which network plane is centralized and manages routing decisions?
A. policy plane
B. management plane
C. control plane
D. data plane
Refer to the exhibit. Which route type is configured to reach the internet?
A. host route
B. default route
C. floating static route
D. network route
How does a switch process a frame received on Fa0/1 with the destination MAC address of 0e38.7363.657b when the table is missing the address?
A. lt drops the frame immediately.
B. It forwards the frame back out of interface Fa0/1.
C. It floods the frame to all interfaces except Fa0/1.
D. It holds the frame until the MAC address timer expires and then drops the frame.
Which function does the range of private IPv4 addresses perform?
A. allows multiple companies to each use the same addresses without conflicts
B. provides a direct connection for hosts from outside of the enterprise network
C. ensures that NAT is not required to reach the internet with private range addressing
D. enables secure communications to the internet for all external hosts
Refer to the exhibit. An access list is created to deny Telnet access from host PC-1 to RTR-1 and allow access from all other hosts A Telnet attempt from PC-2 gives this message:”% Connection refused by remote host” Without allowing Telnet access from PC-1, which action must be taken to permit the traffic?
A. Add the access-list 10 permit any command to the configuration
B. Remove the access-class 10 in command from line vty 0.4.
C. Add the ip access-group 10 out command to interface g0/0.
D. Remove the password command from line vty 0 4.