We HELP you PASS (CCNP 350-401) Implementing Cisco Enterprise Network Core Technologies (ENCOR) certification, without exam and training!
***Pay after you Pass***
Which controller is capable of acting as a STUN server during the onboarding process of Edge devices?
- A. vBond
- B. vSmart
- C. vManage
- D. PNP Server
How is 802.11 traffic handled in a fabric-enabled SSID?
- A. centrally switched back to WLC where the user traffic is mapped to a VXLAN on the WLC
- B. converted by the AP into 802.3 and encapsulated into VXLAN
- C. centrally switched back to WLC where the user traffic is mapped to a VLAN on the WLC
- D. converted by the AP into 802.3 and encapsulated into a VLAN
Refer to the exhibit.
An engineer is installing a new pair of routers in a redundant configuration. When checking on the standby status of each router, the engineer notices that the routers are not functioning as expected.
Which action will resolve the configuration error?
- A. configure matching hold and delay timers
- B. configure matching key-strings
- C. configure matching priority values
- D. configure unique virtual IP addresses
An engineer has deployed a single Cisco 5520 WLC with a management IP address of 172 16.50.5/24. The engineer must register 50 new Cisco AIR-CAP2802I-
E-K9 access points to the WLC using DHCP option 43. The access points are connected to a switch in VLAN 100 that uses the 172.16.100.0/24 subnet. The engineer has configured the DHCP scope on the switch as follows:
Network 172.16.100.0 255.255.255.0
Default Router 172.16.100.1 –
Option 43 ASCII 172.16.50.5 –
The access points are failing to join the wireless LAN controller. Which action resolves the issue?
- A. configure option 43 Hex F104.AC10.3205
- B. configure option 43 Hex F104.CA10.3205
- C. configure dns-server 172.16.50.5
- D. configure dns-server 172. 16.100.1
What is the role of vSmart in a Cisco SD-WAN environment?
- A. to establish secure control plane connections
- B. to monitor, configure, and maintain SD-WAN devices
- C. to provide secure data plane connectivity over WAN links
- D. to perform initial authentication of devices
Which action is performed by Link Management Protocol in a Cisco StackWise Virtual domain?
- A. It determines which switch becomes active or standby.
- B. It determines if the hardware is compatible to form the StackWise Virtual domain.
- C. It rejects any unidirectional link traffic forwarding.
- D. It discovers the StackWise domain and brings up SVL interfaces.
What are two reasons why broadcast radiation is caused in the virtual machine environment? (Choose two.)
- A. vSwitch must interrupt the server CPU to process the broadcast packet.
- B. The Layer 2 domain can be large in virtual machine environments.
- C. Virtual machines communicate primarily through broadcast mode.
- D. Communication between vSwitch and network switch is broadcast based.
- E. Communication between vSwitch and network switch is multicast based.
Which two GRE features are configured to prevent fragmentation? (Choose two.)
- A. TCP window size
- B. IP MTU
- C. TCP MSS
- D. DF bit clear
- E. MTU ignore
Which LISP device is responsible for publishing EID-to-RLOC mappings for a site?
- A. ETR
- B. MR
- C. ITR
- D. MS
Refer to the exhibit.
Assuming that R1 is a CE router, which VRF is assigned to Gi0/0 on R1?
- A. default VRF
- B. VRF VPN_A
- C. VRF VPN_B
- D. management VRF