Pass CCNA 200-301 in Just 3 Days – Stress-Free!
Get your CCNA 200-301 certification with 100% pass guarantee. Pay only after passing!
Click here to secure your guaranteed certification now!
Have questions? Contact us directly on WhatsApp for quick support!
Which three statements about MAC addresses are correct? (Choose three)
A. To communicate with other devices on a network, a network device must have a unique MAC address
B. The MAC address is also referred to as the IP address
C. The MAC address of a device must be configured in the Cisco IOS CLI by a user with administrative privileges
D. A MAC address contains two main components, the first of which identifies the manufacturer of the hardware and the second of which uniquely identifies the hardware
E. An example of a MAC address is 0A:26:B8:D6:65:90
F. A MAC address contains two main components, the first of which identifies the network on which the host resides and the second of which uniquely identifies the host on the network
Which Cisco IOS command will indicate that interface GigabitEthernet 0/0 is configured via DHCP?
A. show ip interface GigabitEthernet 0/0 dhcp
B. show interface GigabitEthernet 0/0
C. show ip interface dhcp
D. show ip interface GigabitEthernet 0/0
E. show ip interface GigabitEthernet 0/0 brief
Which command can you enter to allow Telnet to be supported in addition to SSH?
A. transport input telnet ssh
B. transport input telnet
C. no transport input telnet
D. privilege level 15
Refer to the exhibit. The default-information originate command is configured under the R1 OSPF configuration. After testing, workstations on VLAN 20 at Site B cannot reach a DNS server on the Internet.
Which action corrects the configuration issue?
A. Add the default-information originate command on R2.
B. Add the always keyword to the default-information originate command on R1.
C. Configure the ip route 0.0.0.0 0.0.0.0 10.10.10.18 command on R1.
D. Configure the ip route 0.0.0.0 0.0.0.0 10.10.10.2 command on R2.
Which three describe the reasons large OSPF networks use a hierarchical design? (Choose Three)
A. to speed up convergence
B. to reduce routing overhead
C. to lower costs by replacing routers with distribution layer switches.
D. to decrease latency by increasing bandwidth.
E. to confine network instability to single areas of the network.
F. to reduce the complexity of router configuration.
What is the binary pattern of unique ipv6 unique local address?
A. 00000000
B. 11111100
C. 11111111
D. 11111101
Refer to the exhibit. If R1 receives a packet destined to 172.16.1.1, to which IP address does it send the packet?
A. 192.168.14.4
B. 192.168.12.2
C. 192.168.13.3
D. 192.168.15.5
Which two statements about VTP are true? (Choose two.)
A. All switches must be configured with the same VTP domain name
B. All switches must be configured to perform trunk negotiation
C. All switches must be configured with a unique VTP domain name
D. The VTP server must have the highest revision number in the domain
E. All switches must use the same VTP version.
Refer to the exhibit. On R1 which routing protocol is in use on the route to 192.168.10.1?
A. RIP
B. OSPF
C. IGRP
D. EIGRP
Which two options are the best reasons to use an IPV4 private IP space? (Choose two)
A. to enable intra-enterprise communication
B. to implement NAT
C. to connect applications
D. to conserve global address space
E. to manage routing overhead